Knowledgebase
Dimension Engineering > Help Desk > Knowledgebase

Search help:


Using 4 pole motors with Sabertooth/SyRen

Solution

4 pole motors are compatible with our motor drivers if installed properly. You will need a standard 60-100V, 3A diode for each motor. See attached wiring diagram.

Attachments:
4pole_motor_install.jpg 4pole_motor_install.jpg

 
Was this article helpful? yes / no
Related articles What to do with regenerative current while driver is un-powered and the motors are spun.
Antiparallel diode for Picoswitch
Do I need a fuse between the battery connection and the Sabertooth?
How do I disable R/C autocalibration without turning off the signal timeout on a Sabertooth?
Basic Troubleshooting for Motor Drivers
Article details
Article ID: 6
Category: Motor Drivers
Date added: 2013-06-13 15:31:15
Views: 598
Rating (Votes): Article rated 3.0/5.0 (40)

 
« Go back